Leak Tester Test

Leak Tester Test

Each Leak Tester Set Comprises of the following.
1. Leak Tester (A) with Medium & Small Dummy head.
2. Leak Tester (B) with Medium & Large Dummy head.
3. Power Inverter.
4. Tool Box.

Download Brochure

Request Quote
The leak tester essentially consists of two dummy heads and a suction generator which is connected to a needle valve and flow Meter. The flow meter outlet is connected at the mouth of the dummy Head. A pressure sensor located below the dummy head is also connected to the mouth through an adjacent steel pipe.

When the mask is not fitted on the dummy head, the flow display shows maximum inward flow and suction display shows zero. When mask is fitted, the leak flow rate decreases, the cavity suction level goes on increasing depending on the degree of fitment and tightness of the mask.

The tester is provided with digital display and a logic circuit which indicates within 40 seconds whether a mask has passed / failed. This facility simultaneously compares the test values with admissible values and a comparator network decides whether the masks satisfies the pass / fail criteria. The glowing of green LED indicates the mask has passed. In the event of failure, the reason is also indicated as, suction fail or Flow (leak rate) fails
by glowing of respective red LEDs.

The admissible values for suction and flow are engraved on the top of the panel for quick reference.

Dummy Head

Made of F.R.P. in three sizes; small, medium & Large size.

Suction Pump

Max. Suction 20 inches WC.

Flow Sensor

100 to 1000 cc/min. Turbine Flow Sensor.

Pressure Sensor

0 to (-) 600 mm WC. Diaphragm type.

Digital Indicator/Controller

90 x 90 x 150 mm unit complete with input transformer, power supply board, set point, Set adjust, calibration/zero adjust knob, one set of relay potential free contacts on the rear side, and 3 ½
digits LED Display DPM on front panel.


230 VAC 50 Hz Mains

Power Consumption

110 VA.

Fuse rating

Total kit fuse 2A, 500 mA

Line filter and spike buster

Provided in the power cord connecting unit itself this eliminate EMI/RFI also protects from Lightning.

Pass/fail indication

By LEDs on front panel.